Jack O’Connor’s Winchester Model 101 Skeet Set in 20, 28 and .410. Purchased directly from Winchester by O’Connor in 1967, serial number 232764 was inherited by a daughter in 1978 and then passed to a family friend in 2005. Today, it remains unaltered and presents in high original condition. The shotgun itself features ejectors, mechanical safety and a single select trigger. BARRELS: All three barrel sets are 28-inches long, sport vent ribs with double beads and have dedicated (numbered) forends. Each set is properly serialed and also sequentially numbered large-to-small. Fixed skeet chokes run the table. Both the 20 and 28 gauge sets have 2.75-inch chambers, while the .410 has 2.5-inch chambers. DIMENSIONS: Weight is 6.6 pounds with the 20 gauge barrels. Length of pull is 14 inches, drops are 1.5 and 2.5 inches, and cast off is slight, possibly .20-inch. CONDITION: All bores are pristine. 20 gauge barrels and forend are at least 99%, with only slight indications of wear. 28 gauge barrels and forend are about 98%, with minor finish thinning on the right side of the muzzle from case, trace of freckling near muzzle and on forend release, and minor impressions in forend wood. The .410 barrels and forend are 99.5%, with only the slightest indications of use and handling. Action is approximately 98%, with slight indications of handling and occasional minor freckling. The stock also rates 98%, with scattered minor impressions. Engraving remains sharp and unblemished. The case is at least 97% inside and 95% outside. Even the keys are included. DOCUMENTATION: Letter on Jack O’Connor Center letterhead hand-signed by daughter detailing the ownership chain through 2005 and a field photo of Jack, son-in-law and grandson on a pheasant hunt with this shotgun. A letter from the current owner to the purchaser will also be provided.